This easy-assemble non-penetrating mount works for cellular antennas, TV antennas, parabolic antennas, satellite dishes, wireless internet antennas, weather stations, and many more.
-
Assembly Instructions
Note: A ½ inch socket wrench is required for setup -
Step 1: Arrange L-Channel Pieces
There are six L-Channel bars in the case, labeled #1 and #2. Arrange the two #1 pieces and two of the #2 pieces in a rectangle, then add the remaining #2 pieces in the center.
NOTE: Make sure the central #2 pieces face away from one another with the central squares -
Step 2: Secure with carriage bolts and flange nuts.
Attach the L-Channel bars to one another using included carriage bolts and flange nuts. -
Step 3: Fasten Brace to Base
Attach three brace pieces to the rectangle base using carriage bolts and flange nuts. -
Step 4: Insert and Fasten Pole
Insert pole between three brace pieces and two central L-Channel bars on base. Rotate as needed to attach pole to all brace pieces and central L-Channel bars using hexbolts and washers. -
Step 5: Attach Extension Pole, Place Cinder Blocks, and Adjust as Necessary
The 3-foot extension pole can be easily attached at this point. Cinder blocks should be used to secure the sled mount to a roof, and the angle of the pole can be adjusted as necessary.
Note: Cinder Blocks not included.
- 2x L-Channel #1
- 4x L-Channel #2
- 2x Brace #3
- 1x Brace #4
- 11x Carriage-Bolt
- 11x Flange Nut
- 1x 3 Ft Pole Extensions
- 1x 5 Ft Pole
- 7x Hexbolt M8 x 25
- 7x Washer M8
| Bolton Roof Sled Mount | |
|---|---|
| Part # | BT459655 |
| Pole Height | 96.39" |
| Base Dimensions | 35.23" x 32.52" |
| Box Dimensions | 60" x 5" x 5" |
